EasyManuals Logo

Rotax 912 Series Operator's Manual

Rotax 912 Series
91 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #62 background imageLoading...
Page #62 background image
Cold engine start Engine hard to start at low temperature
Possible cause Remedy
Starting speed too low. Preheat engine.
Low charge battery. Fit fully charged battery.
High oil pressure. At cold start an oil pressure reading
of up to around 7 bar (102 psi) does
not indicate a malfunction.
Oil pressure too low after
cold start.
Too much resistance in the oil suc-
tion system at low temperatures due
to cold oil. Stop engine and preheat
oil. After a cold start the oil tank must
be observed and the oil pressure
should be above 1.5 bar (22 psi).
Otherwise, the speed must be low-
ered again, because not enough cold
oil can be sucked. If oil pressure is
reading lower than 1 bar (15 psi) oils
with lower viscosity are to be used.
See SI-912 i-001, current issue.
NOTE
Oil pressure must be measured at idle at an oil temperature of
minimum 50 °C (120 °F). Be sure the oil pressure does not go
below minimum at idle.
Page 4-8
November 01/2016
BRP-Rotax Effectivity: 912 Serie
Edition 4 / Rev. 0

Table of Contents

Other manuals for Rotax 912 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Rotax 912 Series and is the answer not in the manual?

Rotax 912 Series Specifications

General IconGeneral
Redline5800 rpm
TBO2000 hours
Displacement1211 cc
Bore79.5 mm
Stroke61 mm
Power Output80 hp (59.6 kW)
Compression Ratio9.0:1
Fuel TypeAvgas 100LL
Ignition SystemDual electronic ignition
Fuel SystemFuel Injected
Oil SystemDry sump
Engine Type4-cylinder, horizontally opposed, 4-stroke

Related product manuals