Rotenso CONTROL Series - Wiring to Indoor Unit; Connecting Terminals; Wiring Precautions

LOKA HAHB remote control
EN
58
Installation and user manual
A
B
HA HB
1
44mm
60mm
switch box
Wiring hole
Fig 3-6
Skrzynka rozdzielcza
Otwór na przewody
5. Wire with the indoor unit
1. indoor unit
2. notch the part for the wiring to pass through with nippers, etc.
Connect the terminals on the remote controller (HA ,HB), and the terminals of the
indoor unit (HA ,HB). (HA and HB do not have polarity.)
Fig. 3-6
NOTE:
• DO NOT allow water to enter the wire controller . Use the trap and putty to seal
the wires.
• Connecting wires must be xed reliably and cannot be pulled.