Rotex Solaris User Manual

1 x Safety
6
FA ROTEX Solaris - 08/2007
Validity
Some of the information in this manual only applies/does not apply for certain devices. Validity is indicated by the following
symbols:
1.3 Danger prevention
ROTEX Solaris systems are built in accordance with the state of the art and generally accepted engineering practice. However,
improper use can lead to serious injuries or death, as well as causing material damage. To avoid danger, ROTEX systems should
only be installed and operated:
– As stipulated, and in perfect conditions,
– With an awareness of safety and possible dangers.
This presumes knowledge and application of the information given in this manual, as well as the relevant accident prevention
regulations and the accepted rules on safety and occupational health.
1.4 Intended use
The ROTEX Solaris system may only be used for solar-supported heating of hot water systems. The ROTEX Solaris system may
only be installed, connected, and operated in accordance with the instructions given in this manual.
Any use other than defined above is considered as non-intended (incorrect). The owner will be solely responsible for any resulting
damage.
Intended use also includes the observance of maintenance and inspection specifications. Spare parts must at least satisfy the
technical requirements defined by the manufacturer. This is the case, for example, with original spare parts.
1.5 Instructions for working safely
Working on the roof
• Installation work on the roof may only be carried out by authorised and trained persons (heating technicians, roofers, etc.)
under observance of the relevant Accident Prevention Regulations.
• Material and tools must be secured from falling off.
• Barriers must be erected to prevent persons from entering the area below the roof where the work is being carried out.
Before working on the heating system
• All work on the heating system (such as installation, connection, and commissioning) may only be carried out by authorised
and trained heating technicians.
• Switch off the mains supply before starting any work on the heating system, and secure it against unintentional switch-on.
Electrical installation
• Electrical installations may only be carried out by qualified electrical technicians under observance of the relevant electrical
guidelines and the regulations of the electric utilities company.
• Before connecting to the mains supply, check that the voltage specified on the type label of the heating system (230 V,
50 Hz) is the same as the available supply voltage.
Instructing the user/owner
• Before you hand over the heating system, explain to the user/owner how to operate and check the heating system.
• Make a record of the handover by filling out and signing the installation and instruction forms together with the user/owner.
Valid for ROTEX GasSolarUnit GSU Not valid for ROTEX GasSolarUnit GSU
Valid for ROTEX E-SolarUnit ESU Not valid for ROTEX E-SolarUnit ESU
Valid for ROTEX Sanicube Solaris SCS Not valid for ROTEX Sanicube Solaris SCS

Rotex Solaris Specifications

General

Brand	Rotex
Model	Solaris
Category	Heating System
Language	English