Need help?Do you have a question about the Rotronic HygroPalm Series and is the answer not in the manual?
General| Protection | IP40 |
|---|---|
| Humidity Measurement Range | 0 to 100 %RH |
| Display | LCD |
| Power Supply | Battery |
| Interface | USB |
| Weight | 250 g |
| Calculated Parameters | Dew point, wet bulb temperature |
Explains the RS232 port for PC connection and its uses with HW3/HW4 software.
Introduces the operation section and shows probe and port connections for models.
Selects calibration type: Humidity Standards, reference environment humidity, or temperature.
Details the steps for temperature and humidity calibration points, including rules and sequence.
Selects calibration type: Humidity Standards, reference environment humidity, or temperature.
Shows measurements from probes connected to a remote transmitter.
Displays the configuration and serial number of the connected transmitter.
Allows 1-point adjustment of probes on a transmitter using a HygroPalm probe as reference.
Grants access to transmitter functions, including ADJUST M.PT, on specific models.
Describes how measurements are displayed when the HygroPalm is in Remote Control Mode.
Explains how to access remote unit functions via the MENU key.
Details access to calibration functions when operating in remote mode.
Explains performing a 1-point adjustment in remote mode using a reference probe.
Advises on the frequency and methods for periodic calibration checks.
Explains the requirements and procedure for temperature calibration.
Describes how to perform humidity calibration using certified standards.
To Next Page
