Operating Instructions 18 SG9M Manual
Tapping Operations:
Place the universal 3-jaw chuck or collet holder with the proper split collet in the spindle as explained
previously. Install tap in the chuck, and tighten.
Center over the hole to be tapped
Press green button to start rotation of the spindle and feed down the hole.
Choose a spindle speed sufficient for the tap (approximately 50 RPM), and allow the tap to feed the
spindle as it threads the hole.
When the proper depth is achieved, flip the lever to reverse the spindle and turn the speed control to full
speed to clear the hole.
To Next Page
Loading...