2018-06-20/1.11A
Piranha/Cobia & Quick Check Getting Started
Quick Check
24
When you click or tap here, a menu is shown that allows you to quickly select a different kV range.
When you measure on mammography you might want to change calibration and/or status for the
compression paddle:
The following meter settings are available in Quick Check:
Add a delay after the detection of trig before measurement of kVp starts. This will
delay the kVp measurement, it doesn't affect dose, mAs or time measurements.
This is the time the meter waits after trig off before it assumes that the exposure is
finished. The post delay must be set to a time longer than any dead time in the
radiation.
Calibration for the internal probe.
To Next Page
Loading...
Need help?
General
