RTI VSW-51 - Control Compact Scaler Switcher or 3 Rd Party Device from Local; Control Compact Scaler Switcher or 3 Rd Party Device Form Remote

Compact Scaler Switcher Set
24
4.3.4 Control Compact Scaler Switcher or 3rd Party Device from Local
Firstly, according the following connection diagram to connect all devices as needed.
Secondly, send command “#CFG:OUT01RS232M1!”(serial control mode 1, factory
default) via RS232 communication software.
Lastly, send the right command of the Scaler Switcher or other remote RS232 device
connected in present system. Connect as below:
Control Compact Scaler Switcher or 3rd party device from local
4.3.5 Control Compact Scaler Switcher or 3rd party device form Remote
Firstly, according the following connection diagram to connect all devices as needed.
Secondly, send command “#CFG:OUT01RS232M2!” via RS232 communication
software.
Lastly, send the right command to control the Scaler Switcher. Connect as below:
3rd party
PC
48V LINE IR EYEIR IN
IR OUT
MIC INPUT
MIC
FIRMWARE AUDIO OUT
L R
RES RESET
RS232
Tx
Rx
L R
INPUTS OUTPUTS
3-HDMI
2-HDMI1-HDMI / MHL 4-DP 5-VGA HDMI
HDBT
CONTROL
DC 24V
I R
O U
T
I R
I N
H
D M I
O U
T
HDBT IN
Tx Rx
HDBaseT Receiver