28
Configuring the Access Point
Configuring for Standalone Operation or for Management by FlexMaster
3. If you made any changes to the Common tab, click Update Settings.
4. Continue to “Configure Wireless # Settings”
below.
Figure 23. The Configuration > Radio 2.4 > Common tab
Country Code
• If you purchased the Access Point in the United
States, this value is fixed to United States at the
factory and is not user configurable.
• If you purchased the Access Point outside the
United States, verify that the value is set to your
country or region. Selecting the correct country
code ensures that the Access Point uses only the
radio channels allowed in your country or region.
NOTE: The two radios on ZoneFlex 7762 AP are always
configured with the same country code setting. If you
change the country code for Radio 2.4G, for example,
the same change will be automatically applied to
Radio 5G.
Table 4. Common wireless configuration
Setting Recommended Value
To Next Page
Loading...
