VLT
Vertical Process Pump
12 V1.090418
2.6 SAFETY INSTRUCTIONS RELEVANT FOR MAINTENANCE, INSPECTION AND
ASSEMBLY WORK
It is the plant operator's responsibility to ensure that all maintenance, inspection and assembly work
is performed by authorized and qualified personnel who have adequately familiarized themselves
with the subject in matter by studying this manual in detail.
Any work on the machine shall only be performed when it is at a standstill. To shut off the machine it
is imperative to follow the procedure for shutting down the machine as described in SECTION 7.5-
STOPPING.
Pumps and pump units that convey hazardous materials must be decontaminated before any
maintenance work is performed.
On completion of work all safety and protective facilities must be re-installed and made operative
again.
Prior to restarting the machine, follow the instructions listed under SECTION 7.2-STARTUP.
2.7 UNAUTHORIZED ALTERATIONS AND SPARE PARTS
Modifications may be made to the machine only after consultation with a Ruhrpumpen
representative.
Using spare parts and accessories authorized by Ruhrpumpen is in the interest of safety. The use of
parts not authorized by the dealer exempt the manufacturer from any liability, voiding the warranty.
2.8 UNAUTHORIZED MODES OF OPERATION
The reliability of the machine is guaranteed if and only if it is used in the intended manner, in
accordance with the statutes of this manual. The limit values specified in the data sheet must never
be exceeded under any circumstance.
To Next Page
Loading...