User
’
s Manual of RDC644XG Control System
SHENZHEN RUIDA TECHNOLOGY
origin logic. Next origin can be modified to any one of origin 1~4, so as to control the
start location of next work (the premise is that the origin is enabled), but it can’t be
Once the multiple- origin logic is selected and if the serial number of
the next origin is 1 and four origins are enabled, when the memory file
function is started or the processing file is uploaded into the PC and
this file selects “Take the Original Origin as current Origin”, the work
started for each time will use different origins. The rotation order of
origin is 1->2->3->4->1->2…….
8.3.7 Set Fact Para
After the “Set Fact Para” is selected and the Enter key pressed, the interface will show the specific
password to be entered when set as default parameter.
Push “X+/-” keys and “Y+/-” keys to select the characters, and push the “Enter” key to valid the
characters, when finishing enter the password ,that is to say, the six characters, if the password is
error, it prompts there is some error, or, all parameters are stored.
After the manufacturer regulates all parameters of the machine
well (including all manufacturer parameters and user parameters),
this function can be used to store the well-regulated parameters to
help users to recover the original parameters (including all
manufacturer parameters and user parameters) through selecting
“Recover Para” when they regulate parameters improperly.
To Next Page
Loading...
Need help?
General