Web-based Configuration Guide Basic Management
45
Note
● VLAN ID range is from 1 to 4094, among which VLAN 1 is the default VLAN that cannot be deleted.
● When hardware resources are insufficient, the system displays a VLAN creation failure message.
● Improper configuration of VLANs on a port (especially uplink port) may cause the failure to log in to the
Eweb management system. Therefore, exercise caution when configuring VLANs.
3.5.4 Batch Switch Configuration
1. Overview
You can batch create VLANs, configure port attributes, and divide port VLANs for switches in the network.
2. Procedure
Choose Network > Batch Config.
(1) The page displays all switches in the current network. Select the switches to configure, and then select the
desired ports in the device port view that appears below. If there are a large number of devices in the current
network, select a product model from the drop-down list box to filter the devices. After the desired devices
and ports are selected, click Next.
(2) Click Add VLAN to create a VLAN for the selected devices in a batch. If you want to create multiple VLANs,
click Batch Add and enter the VLAN ID range, such as 3-5,100. After setting the VLANs, click Next.
To Next Page
Loading...
Need help?
General