26
English
MIN. TEMPERATURE
094
STOP COFFEE
** 00000 LIM:00990 *
STOP BEVERAGE
BEVERAGE A
** 00000 LIM:00990 *
STOP SOLUBLES
SOLUBLE 1
** 00000 LIM:00990 *
RESET
— ->Y< N ++
BEVERAGE CHECK
— s s c S W C d ++
Press ENTER to activate the blinking cursor to modify the “limit” numbers
and press the “+” or “-” buttons to modify the value. Press ENTER again to
confirm this modification. Press the “+” and “-” buttons to proceed to the
next message.
Press ENTER and the “+” and “-” buttons to display in sequence the ten be-
verage selections and their corresponding “stop values”.
When ENTER is pressed upon reaching a desired beverage, the blinking
cursor will be activated. Press the “+” and “-” buttons to modify the value.
Press ENTER and the “+” and “-” buttons to display in sequence the four so-
luble products and their corresponding “stop values”. This menu allows you
to program the quantity of dispensed soluble product. When this quantity
has been reached, the dispensing of all beverages containing that soluble
product will automatically stop. The counter deducts from the product which
uses the highest amount of that soluble product. Beverages using smaller
quantities of that soluble product are counted as fractions of a unit.
When ENTER is pressed upon reaching a desired beverage, the blinking
cursor will be activated. Press the “+” and “-” buttons to modify the value.
It allows you to reset all abovementioned values preceded by “**”. By pres-
sing ENTER, the blinking cursor appears. Use the “+” and “-” buttons to se-
lect the reset mode (
YESYES
YESYES
YES), then confirm by pressing ENTER.
It allows you to do a test dispensing of any beverage (without leaving the
programming mode) by activating or disabling single items to check the
quantity. The second line on the display indicates a series of characters
corresponding to the following items:
S:Sugar
S:Stir stick
C:Cup
S:Soluble product
W:Water for soluble product
C:Coffee
D:Decaffeinated coffee
Activating the letter D: decaffeinated coffee; the test dispensing will occur
only if decaffeinated replaces the coffee beans. The activation of letter D
automatically disables the letter C, and vice versa.
By pressing ENTER, a blinking cursor appears under the first character. By
pressing “+” and “-”, the character is changed from upper case to lower
case. “Upper case character” = activated item; “Lower case character” =
disabled item. After each selection, press ENTER to move the cursor to the
next character. Only activated items will be dispensed when the beverage
button is pressed. If the beverage is composed of more than one enabled
soluble product, they are dispensed in sequence. Carry out the same proce-
dure for the water of the soluble products. To return to the previous menu,
press the CANCEL button repeatedly ref. 5 (Fig. 23). The settings return to
their default characters (s s c S W C d).
It allows you to set the temperature that the machine maintains for approx.
5 minutes after dispensing a beverage. The set value expressed in degrees
centigrade appears on the second line of the display. By pressing ENTER,
the blinking cursor appears. Use the “+” and “-” buttons to modify the va-
lue. Press ENTER to confirm.
To Next Page
Loading...
