43
65
4
After approximately 2000 grinding cycles, the grinder needs a slight adjustment to ensure it is running in
peak condition.
WARNING!
This operation should be carried out carefully and by an experienced user. The screw could fall into the
grinder; if it happens remove it before restarting the machine. Protect the grinder hole with a cloth to avoid
this problem. The snap is signalled by a message on the coffee bean hopper; refer to these messages when
this adjustment is performed.
EMPTY THE COFFEE BEAN HOPPER.
GRINDER MAINTENANCE
Adjust until it clicks.Remove screws and service door.
Unscrew the screw that holds the
service door closed.
Then reposition the door and attach it with the previously removed screw.
10 1211
Apply the grease evenly. Insert the coffee grounds drawer.
Close the service door.
Insert the washed and dried Brew
Group. DO NOT PRESS THE
“PUSH” BUTTON.
3
Repeat the cycle, turn off the
machine and unplug it.
1
Press and dispense two coffees.
2
add coffee
beans
ok
When the following display appears,
press “ok” and repeat the
operations from point (1) just once.
show icon
explanation
my custom
coffee
program-
ming
menu
To Next Page
Loading...
