SAGEMCOM FAX 4575 - TELEPHONE LINES AND ADDITIONAL DEVICES; SELECTING THE DIALLING PROCESS; SET UP PRIVATE BRANCH EXCHANGE (PABX)

46 Sagemcom · FAX 4560 · FAX 4565 · FAX 4570 · FAX 4575
EN
11 TELEPHONE LINES AND
ADDITIONAL DEVICES
SELECTING THE DIALLING
PROCESS
Function is not supported in all countries and networks
(Function is not supported in all countries and net-
works)
In some countries you can set the dialling mode to
pulse dialling or tone dialling (DTMF tones).
Selecting the Dialling Process
1 Press OK, 053 and OK.
2 Use [ to select the desired dialling process.
3 Confirm with OK.
SET UP THE PUBLIC SWITCH
TELEPHONE NETWORK (PSTN)
Function is not supported in all countries and networks
(Function is not supported in all countries and net-
works)
Public Switch Telephone Network (PSTN)
Set up the Public Switch Telephone Network (PSTN)
Your device is automatically adjusted to the tele-
phone network if you set the country correctly (see
also chapter
Selecting the Country, page 39). It is
possible that further settings are required for the
Public Switched Telephone Network (PSTN). Ask
your retailer or the technical customer service
department.
1 Press OK, 032 and OK.
2 Select the desired setting using [.
3 Confirm with OK.
SET UP PRIVATE BRANCH
EXCHANGE (PABX)
PABX Systems
Private branch exchanges (PABX) are typical in many
offices and some households. You must dial an out-
side line access code in order to get a connection to
the public telephone network (PSTN) from a PABX.
Additional Telephone No Extension
Set up Private Branch Exchange (PABX)
You can set up your device for operation on an exten-
sion, indicate the length of the internal numbers
(direct dial number) and save the code which must be
selected in order to reach the Public Switched Tele-
phone Network (PSTN) (= outside line access code).
Outside Line Access Code is Automatically Dialled
SET THE CONNECTION TYPE
1 Press OK, 051 and OK.
2 Use [ to set whether you operate your device on
an extension.
3 Confirm with OK.
SET THE OUTSIDE LINE ACCESS
CODE
ENTER THE LENGTH OF THE DIRECT DIAL
NUMBER
1 Press OK, 0521 and OK.
2 Enter the appropriate length for internal numbers.
Use C to delete individual characters. Assume the
longest internal number, then add one digit to
that. If your direct dial numbers consist of four
digits, then you should input
5.
3 Confirm with OK.
Notice
SELECTING THE DIALLING PROCESS
Only use pulse dialling if tone dialling is not
yet activated for your telephone line.
Notice
PUBLIC SWITCH TELEPHONE NETWORK
(PSTN)
You can use this function to set your device
to connect to the Public Switch Telephone
Network (PSTN). To connect to a Private
Branch Exchange (PABX) see also chapter
on
set up Private Branch Exchange (PABX)
, page 46.
Notice
ADDITIONAL TELEPHONE NO EXTENSION
An additional telephone connected to the
device on a telephone socket is not consid-
ered an extension.
Notice
OUTSIDE LINE ACCESS CODE IS AUTOMAT-
ICALLY DIALLED
Once these settings are in place, you will no
longer need to prefix the outside line access
code every time you enter an external
number. The device will automatically add
the outside line access code in front of
numbers that are the same length or longer
than the configured direct dial numbers.