Chapter 2: Operation
38 Setup
The recorded channel is displayed. The message length is shown in seconds.
The display shows how old the message is. If the 240 s storage limit is
reached, the oldest data is overwritten.
Replaying recorded messages
To replay a message do as follows:
1. Press the Replay button (short press). The latest message
(message) is repeated. Information about this message is shown in the
display.
2. To stop replaying the message press the soft key STOP.
3. To rewind through the recorded messages make a long press on the Replay
button.
4. To stop replaying a message press STOP or the PTT button on the speaking
device.
If a signal is received while in replay mode the display shows in the
display.
Setup
The following setup pages are described in this section of the manual:
• Radio setup
• Channel setup
• Power Supply
• DSC setup
• DSC call logs
The replay function can be started even in a distress situation. If a
DSC call is received the replay function continues the playback.
Acknowledgement of the DSC call immediately initiates and activates
the DSC session. You can initiate replay again from any session
afterwards.
To Next Page
Loading...
