Controller setup
Each of the controlling devices connected and powered has its own setting.
The available settings may vary from controllers applied.
Factory Defaults Resets the radio to factory defaults. Press the
selector wheel knob and confirm the reset to
factory default.
Radio Info: SW Version: Software version of the radio
S/N: Serial number of the radio
TU IP: IP address of the radio
Password If you need to change the identity of the radio
(MMSI number or ATIS code), contact your local
dealer.
SYSTEM SETUP Description
Controlling device Description
Handset 1 vol: Adjust earpiece volume for handset 1: ON, can be
adjusted OFF and from 5 to 100, in steps of 5.
Note: The handset connected to the front connector has
top priority and is configured to ON. The volume can be
adjusted from 0 to 500, in steps of 5.
Handset 2 vol: Adjust earpiece volume for handset 2: OFF, can be
adjusted from 5 to 100, in steps of 5.
Note: If a handset is connected to the rear connector
this value must be configured to a value (1-14).
Ext. speaker FIX: Fixed level is set for external speaker
REL: Relative level following volume adjustment of the
internal speaker
Ext. fixed vol: External speaker fixed volume:
OFF, 5 to 100 in steps of 5
To Next Page
Loading...
