• System setup
• Controller setup
Accessing a setup page
To change a setting in one of the SETUP pages, do as follows
1. Press the soft key SETUP. If it is not in the display, press the soft key MORE
until SETUP appears.
2. Press the arrow soft key or to advance to SETUP page you want to
edit.
3. Turn the selector wheel knob to go to a setting, then press the selector
wheel knob to change the setting.
4. Press EXIT to return to normal radio operation.
Radio setup
Para-
meter
Description
Scan Hang
Time
Scan hang time, in seconds on an active receiving working
channel. The time is measured from the signal is detected. The
radio remains on the channel for the set time interval, if a signal
was detected.
OFF: Resumes scanning when signal disappears (default)
4, 6, 8, 10: Hang time in seconds.
Scan
Resume
Scan resume time, in seconds. When the programmed time of
inactivity has elapsed, and when watch/scan has been aborted
using a press on PTT, or after power-up, scan or watch is
resumed.
OFF: Automatic resume is deactivated (default)
3, 6, 10, 15, 20, 25, 30: Resume time in seconds.
To Next Page
Loading...
