Sainlogic FT0300 - Viewing the High and Low Alarms; Setting the Alarms

26
8.2 Viewing the High and Low Alarms
To view the current alarm settings, press the ALARM key to enter the
alarm mode. HI AL 1 will be displayed in the date area. At the same
time Alarm 1 time and HI alarm parameters of indoor
temperature/humidity, outdoor temperature/humidity, rain rate, AT, feels
like, wind gust, wind average, absolute pressure, UV index, Sunlight,
Sensor(CH1) temperature/humidity and dew point are displayed. Press
SET/MODE key to view Alarm 2 time and HI alarm parameters of indoor
dew point, 24h rainfall, outdoor dew point, relative pressure and
Sensor(CH1) heat index.
Press ALARM key again to view the LOW alarms along with the alarm
clock time the same way HI alarms.
Press the SNOOZE key at any time to return to the normal mode.
8.3 Setting the Alarms
Press ALARM key to enter the alarm mode.
Press and hold the SET/MODE key for three seconds. The first alarm
parameter will begin flashing (alarm hour).
To save the alarm setting and proceed to the next alarm parameter,
Press (do not hold) the SET/MODE key.
To adjust the alarm parameter, press the [+] or [-] key to increase or
decrease the alarm settings, or press and hold the [+] or [-] key for
three seconds to increase or decrease the alarm settings rapidly.
Press the ALARM key to turn on (the alarm icon will appear ) and off
the alarm.
Press the SNOOZE key once at any time to return to the normal mode.
After 30 seconds of inactivity, the alarm mode will time out and return to
normal mode.
The following is a list of the individual alarm parameters that are set (in
order):