Sainlogic WS-0835 - Page 31

31
Make sure the remote sensor LCD display is
working and the transmitter light is flashing once
per 60 seconds.
Install a fresh set of batteries in the remote
thermo-hygrometer. For cold weather
environments, install lithium batteries.
Make sure the remote sensors are not
transmitting through solid metal (acts as an RF
shield), or earth barrier (down a hill).
Move the display console around electrical noise
generating devices, such as computers, TVs and
other wireless transmitters or receivers.
Move the remote sensor to a higher location.
Move the remote sensor to a closer location.
Indoor and
Outdoor
Temperature do
not agree
Allow up to one hour for the sensors to stabilize
due to signal filtering. The indoor and outdoor
temperature sensors should agree within 4 °F
(the sensor accuracy is ± 2 °F).
Use the calibration feature to match the indoor
and outdoor temperature to a known source.
Indoor and
Outdoor Humidity
do not agree
Allow up to one hour for the sensors to stabilize
due to signal filtering. The indoor and outdoor
humidity sensors should agree within 10 % (the
sensor accuracy is ± 5 %).
Use the calibration feature to match the indoor
and outdoor humidity to a known source.
Display console
contrast is weak
Replace console batteries with a fresh set of
batteries.