SAJ 8000m Series User Manual

8000m Series
- 29 -
3.2.2 Fault Reset
When inverter malfunction occurs, it will display the relative fault information. Use
the RUN/STOP key or terminals (determined by F5 group) to reset the fault. After
fault reset, inverter is at stand-by status. If not reset when inverter is at fault status, it
will keep operation protection status and cannot run.
3.2.4 Password Setting
When F7.00 is set to be non-zero, the parameter will be the user’s password.
After exit the function code editing status, the password will be effective after
one minute. And then press the PRGM key again to try to access the function
code editing mode, the inverter panel will display “0.0.0.0”. The password
must be input correctly to access it. If it is necessary to cancel the password
function, set F7.00 to zero.
Notice: When the inverter is powered on, system will execute initialization first and
inverter panel displays “A13” with four lights on. After initialization, inverter
accesses into stand-by status.

SAJ 8000m Series Specifications

General

Brand	SAJ
Model	8000m Series
Category	Controller
Language	English