SAJ 8000m Series User Manual

8000m Series
- 86 -
Attached Table 2 Instruction of Acceleration/Deceleration Time
Terminal 2 Terminal 1
Seletion of
accleration/decelerat
ion time
Corresponding
parameters
OFF OFF Acceleration
time1
F0.18、F0.19
OFF ON Acceleration
time2
、
F8.03 F8.04
ON OFF Acceleration
time3
、
F8.05 F8.06
ON ON Acceleration
time4
、
F8.07 F8.08
Sensitivity setting of the multi-function digital input terminals: If the digital input
terminals are interfered and result in malfunction in some cases, increase this
parameter setting for better anti-interference, but maybe the terminal sensitivity will
then decrease also.
This parameter defines 4 control modes of VFD by terminal inputs.
0: 2-wire control mode 1. This mode is the most usual one. By terminal command
of M1(FWD) and M2(REV), the motor will run forward or reversed as shown in
the following table and wiring diagram.
F5.10
On/off filter times Factory Setting 5
Setting Options
1～10
F5.11
Terminal control mode Factory Setting 0
Setting Options
0:2-wire control mode 1
1:2-wire control mode 2
2:3-wire control mode 1
3:3-wire control mode 2

SAJ 8000m Series Specifications

General

Brand	SAJ
Model	8000m Series
Category	Controller
Language	English