OPERATION
The EP101 is configured and
adjusted by the use of an intuitive
user interface with a minimal
number of user controls.
The backlit LCD gives a highly
visible, easily readable indication of
the controller status.
Setting the Time
Press and hold SET and SELECT when the EP101 is in Normal mode for three
seconds to enter the Clock setting mode. Releasing both keys will display
“12 hr” or “24 hr” and SET, as shown below:
Release the SET and SELECT keys and
press UP or DOWN to toggle between 12
and 24 hour time format.
Pressing and releasing SELECT will then display the time and a SET
indicator, with all other indicators cleared from the display. The hour part
of the time will be flashing to indicate that it is the currently selected item
and is ready to be adjusted.
Press the UP or DOWN keys to increase or
decrease the hour setting – the selected
item will stop flashing while a key is
pressed, and will resume flashing when
you release the key.
Press the SELECT key to select the ‘minutes’ section of the time. Set the
minutes in the same way as the hour by using the UP and DOWN keys.
EP101 INSTRUCTION MANUAL
10
To Next Page
Loading...
Need help?
General
