Pressing the SELECT key allows you to step through each of the items to be
reviewed or adjusted within the programmes in the following sequence:
Programme Status Function Sequence
1 ON Hour Minutes
1 OFF Hour Minutes
2 ON Hour Minutes
2 OFF Hour Minutes
3 ON Hour Minutes
3 ON Hour Minutes
…before then allowing you to cycle back to programme 1. Pressing the SET
key at any time will confirm the setting and return to the programme set
selection. Each programme for all the other days of the week is set in exactly
the same way – just repeat the steps shown above, after entering
programming mode and selecting the day you want to programme.
Regardless of which programming mode the EP101 is set for (5/2 or 7 day),
not pressing any keys for 15 seconds will automatically save any
programming changes and exit to Normal mode. Programmes can be
reviewed or changed even if temporary override mode is enabled.
Please be aware that each of the programme time settings must be in
sequence: for example, the OFF time cannot be earlier than the ON time,
programme 3 cannot be set with a time earlier than Programme 2. If this
situation occurs, then the EP101 may operate in an unpredictable way.
EP101 INSTRUCTION MANUAL
15
To Next Page
Loading...
