User Messages •
••
• 41
User Messages
E00
The wrong key sequence has been used.
- Press CLEAR
E1
A PLU code greater than 500 has been entered.
- Enter a valid code between 1 and 500
E2
A Clerk code greater than 10 has been entered.
- Enter a valid code between 1 and 10
E3
The amount count (quantity) is over the limit.
- Enter an amount below the value limit.
E4
The date and time are required.
- Program the date and time
E5
A limit restriction has been added to this key preventing an amount entry.
- This function has been programmed, see function status to remove limit
E7
The item limit in the transaction has been reached.
- Finalise the sale and begin another transaction
E8
The Subtotal is required.
- Press the SUBTOTAL key and continue with the action.
E9
It is not possible to void this item.
- Continue with normal operation.
E10
This function is programmed only to accept a preset value.
- Ensure a preset amount has been programmed to function or sales item.
E11
This function is programmed only to accept a manual value.
- Enter the required value for this function.
E12
This operation requires an amount entry.
- Enter the amount appropriate to the operation being carried out.
E13
The requested function is not valid.
- Attempt an accepted operation.
E14
Electronic Journal report is full.
- Reset the report with or without a print as per the reports chapter
E15
It is necessary to declare amount of monies in drawer before report print.
- Refer to the cash declared section within the reports chapter.
E16
It is necessary to run a Z report as the next action.
- Refer to the reports chapter for valid reporting operations.
E17
Inactive function.
- This function is set as inactive, see function status to enable key.
E20
Mode password is required.
- Refer to the mode password chapter.
E21
Printer stops to be cooling of printer.
PEA
Receipt paper near end and/or The paper arm is not shut correctly.
- Insert a new 57mm thermal paper roll and/or close the paper arm
To Next Page
Loading...
