Sam4s ER-420 Series - System Option Table

92 • Program Mode Programming ER420 Series
System Option Table
Address SYSTEM OPTION VALUE = SUM
1
Beeper is active? Yes = 0
No = 1
direct entry = 0
2
Clerk sign on method
is:
code entry = 1
pop-up = 1
3
Clerks are:
stay down = 0
Drawer needs to be shut to operate? Yes = 0
No = 1
4
Activate open Drawer Alarm? Yes = 2
No = 0
5
The number of seconds before the open drawer
warning tone sounds
(default is 30 seconds).
1-99
Allow the post tender function? Yes = 1
No = 0
Open drawer on post tender? Yes = 0
No = 2
6
Allow multiple receipts? Yes = 4
No = 0
Cash Declaration Required before Z Financial
report?
Yes = 1
No = 0
7
Allow negative balance sales in the X control
lock position only?
Yes = 2
No = 0
Allow zero balance sales in the X control lock
position only?
Yes = 1
No = 0
8
Consecutive number is reset after a financial
report?
Yes = 2
No = 0
Reset Grand Total after Z financial Report? Yes = 1
No = 0
Cash drawer will open when reports are run? Yes = 0
No = 2
9
Open drawer during training mode? Yes = 0
No = 4
10
Decimal place : (0,1,2,3) default=2 0-3
MMDDYY = 0(default)
DDMMYY = 1
11
Date format is:
YYMMDD = 2