ADJUSTMENT OF END FLOAT IN THE AGROSHIFT UNIT (fig 11)
Screw one M8x1,25x30 bolt
finger tight
into the cover W (fig 11), so as to hold the centre shaft of the H-M-L unit in
position during the adjustment.
Measure dimensions X and Y with a gauge then calculate (X - Y - 1 mm) , which gives the thickness of the thrust
washer K to fit.
Example: values measured X = 135.64 Y = 131.56
(135,64 - 131,56 - 1) = 3,08 ~ 3 mm (washer required is p/n 2.1599.729.0/10)
IMPORTANT: the thrust washer must be selected from those available to give either the exact thickness, or the next
thickness down from the value calculated.
washer p/n 2.1599.724.0/10 thickness 2 mm
2.1599.725.0/10 thickness 2.2 mm
2.1599.726.0/10 thickness 2.4 mm
2.1599.727.0/10 thickness 2.6 mm
2.1599.728.0/10 thickness 2.8 mm
2.1599.729.0/10 thickness 3 mm
2.1599.730.0/10 thickness 3.2 mm
2.1599.731.0/10 thickness 3.4 mm
2.1599.732.0/10 thickness 3.6 mm
2.1599.733.0/10 thickness 3.8 mm
2.1599.734.0/10 thickness 4 mm
Locate the preassembled unit J in the AGROSHIFT housing, applying sealant (Pianermetic 510) between the mating
surfaces of the housings; take care that the sealant is kept well clear of the oil inlet ports.
Remove the temporary positioning bolt to free the centre shaft of the H-M-L unit, then fit the special plug together with
a sealing washer.
Fig. 11 - Location of the preassembled AGROSHIFT unit in its housing.
clutch transmission
agroshift
27
2
125
www.maskinisten.net
www.classicmachinery.net
To Next Page
Loading...