transmission
gearbox
3
31
Fig. 50 - Install the Agroshift unit and gearshift assembly,
complete, in the rear transmission housing. Apply Silastic 738
sealant to one of the mating surfaces before uniting (on
machines without Agroshift, proceed with fitment as for stand-
ard gearshift only).
Fig. 51 - Transmission housing complete with Agroshift unit.
Fig. 48 - Having located the bolts, tighten with a torque wrench
to 8,5 kgm for Silver 80 - 90 - 100.4 machines and 17 kgm
for a Silver 100.6.
Fig. 49 - Rear transmission housing complete with trumpet
housings.
Fig. 46 - Important: to facilitate assembly of the trumpet
housing, it is good policy to fit centralizer dowels p/n
5.9030.537.0 to the transmission housing. Apply sealant (Pia-
nermetic 510) to the surface of the trumpet housing.
Fig. 47 - Position the trumpet housing using a hoist, taking
care to locate the halfshaft in the epicyclic train internally of
the housing.
Main assembly operations involving transmission housing, rear axle, hydraulic lift and engine.
160
www.maskinisten.net
www.classicmachinery.net
To Next Page
Loading...