Fig. 3 - Brake control assembly parts.
Fig. 4 - Brake pump control unit.
Hydraulic pump
Disassebly and checking procedure
Referring to fig 4:
— Remove guard boot A, take snap ring B and withdraw
rod C along with the support disk.
Referring to fig 6:
— Fix the pump in a vice provided with protective jaws and
pushing pistons into the pump partly, as shown in figure 6,
loosen the piston retaining screws and then remove the pistons
together with the spring down below.
A Oil reservoir
B Oil pressure lines
C Oil cylinders
D Pipeline connecting cylinders
E Latch
F Valve block for types without front
brakes
G SEPARATE BRAKES valve
H Brake pedals
I Parking brake lever
L Ratchet sector
M Control rod
N Adjustment clevis
vehicle
brakes
54
5
216
www.maskinisten.net
www.classicmachinery.net
To Next Page
Loading...