SAME SILVER 100.6 - Electronic Power-Lift Specifications; Operation of the Electronic Power-Lift

Technical specifications
manufacturer SAME - DEUTZ FAHR GROUP
hydraulic power-lift type by electronics administration
hydraulic pump type standard pump 2.4529.740.0
with oversized pump 2.4529.780.0/10
hydraulic pump delivery (peak engine
r.p.m.): standard pump l/min 41
with oversized pump l/min 57,5
pressure relief valve setting bar 180+10
minimum allowable piston diameter: SILVER 80 - 90 mm 109.900
SILVER 100.4 - 100.6 mm 124,900
maximum auxiliary hydraulic cylinder: SILVER 80 - 90 mm 110,050
SILVER 100.4 - 100.6 mm 125,050
maximum auxiliary hydraulic cylinder
SILVER 80 - 90 mm 42
SILVER 100.4 - 100.6 mm 50
Lifting capacity with load concentrated on
the lower link ball ends at rear wheel
centre height: SILVER 80 - 90 mm 3157
SILVER 100.4 - 100.6 mm 3897
- with auxiliary hydraulic cylinders SILVER 80 - 90 mm 4329
SILVER 100.4 - 100.6 mm 4339
- hydraulic cylinder securing screws kgm 30
Nm 300
power-lift oil level pipe tightening torque SILVER 80 - 90 kgm 13,5
Nm 132
Operation
The electronic lift is controlled by a control unit and a control panel.
The electronic control unit comes in the standard or SBA (automatic diff-lock, 4WD and Slip control ) versions.
The electronic rear lift control is comprised of a system which, on the basis of incoming information gathered by a
series of sensors and of the operating mode set by the operator on the control panel, pilots two proportional solenoid
valves of a hydraulic directional control valve. The latter in turn controls one hydraulic cylinder, which move the lift arms
carrying the implement.
Main control switch
The following description refers to Fig 2).
The main control consists in a rocker switch located on the left of the console and used by the driver to move the
implement up (5 - Fig 2) and down (6 - Fig 2). The device is proportioned in such a way as to ensure ease of operation.
59
5
vehicle
electronic power-lift
230
www.maskinisten.net
www.classicmachinery.net