Fig. 12 - Fitting the front window glass.
A - adhesive
C - glass
S - silicone sealant
X - seal
body
driving position
Fitting the seals for the rear window, side windows and doors
Apply the seal to the edge of the glass, positioning it in such a way that
the bulbous side is directed toward the interior of the cab; the ends should
join in alignment with the bottom hinges, in the case of the doors and
side windows, whereas for the rear window, the join should be located
mid way along the bottom edge.
Once the entire periphery of the glass has been banded, cut off the
excess rubber in such a way that the two joined ends are faultlessly in
abutment.
Apply liquid rubber compound to the two ends of the seal so that the
internal metal clip will not rust over time.
Insert two rubber connectors p/n 010.1502.0 into the holes of the profile
and stick the two joined ends with an adhesive such as "Bostik 5242/C",
or alternatively " AREXONS UNIVERSAL".
As an alternative to the two rubber connectors, it is also acceptable to
use two lengths of 6 mm sheath for electrical cables and glue the ends
with Loctite 401.
Fig. 13 - Positioning the seals.
LIQUID RUBBER
71
7
345
www.maskinisten.net
www.classicmachinery.net
To Next Page
Loading...