Fig. 13/a - Cab air filter unit.
1 - Air filter
2 - Protective grille.
Cab air filter
Periodically (as dictated by operating conditions): clean the filter.
The 2 knobs retaining the grille also support the filter itself; these must therefore be unscrewed so that the filter can
be removed.
The filter is cleaned as follows:
— blast with compressed air (6 bar max) in the direction opposite to that of normal filtration, until all accumulated dust
has been dislodged;
— wash for about 15 minutes in a solution of detergent and water at 40 °C;
— rinse clean in running water;
— leave to dry naturally at ambient temperature.
Important: the filter must be replaced if damaged, or renewed routinely after cleaning 6 times.
Screen wash
Periodically (as dictated by operating conditions):
check the level of screenwash liquid in the plastic container located at the rear of the machine.
In the event of the jet being rendered defective by an obstruction, this will be remedied generally by freeing the nozzle
outlet with a pin.
If necessary, reposition the nozzle so that the jet strikes the screen at the top of the sweep made by the wiper blade.
It is good policy during winter months to add antifreeze solution to the screenwash liquid, or methyl alcohol.
Warning: it is important that all glass in the cab is kept thoroughly clean.
The rear view mirrors must always be kept clean and properly positioned.
Screen wipers (front and rear)
The wiper blade has a bayonet fitting.
The blade is removed by lifting the catch of the central mounting.
body
driving position
71
7
346
www.maskinisten.net
www.classicmachinery.net
To Next Page
Loading...