EasyManua.ls Logo

SAME SILVER 100.6 - Page 241

Default Icon
470 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Alarm 34 (Radar faulty)
This alarm will be activated in the event that:
The Radar is not connected
The Radar has developed a fault
The wiring is defective or short circuiting
The electronic control unit is faulty
To remedy the trouble, check initially:
That the connector of the device and the relative wiring are properly connected
That the lead connecting the device to the electronic control unit is electrically sound
That the lead is not short circuiting to earth
Alarm 35 (EPROM fault)
This alarm will be activated if parametric system configuration data stored by the internal memory of the
electronic control unit has become corrupted.
A fault of this nature can only be remedied by replacing the electronic control unit.
Alarm 51 (Steering sensor disconnected - versions with SBA system only)
This alarm will be activated in the event that:
The sensor is faulty
The relative wiring is not connected to the sensor
The wiring is short circuited to earth
The electronic control unit is faulty
To remedy the trouble, check initially:
That the steering sensor connector and the relative wiring are properly connected
That the lead connecting the sensor to the electronic control unit is electrically sound
That the lead is not short circuiting to earth
Alarm 54 (Wrong wheel constant)
This alarm will be activated if the constant entered for the wheel speed sensor has been set to zero (signifying no
sensor), although the electronic control unit continues to receive signals confirming that the sensor is installed and
connected. In this instance the fault is due simply to incorrect programming of the electronic control unit.
To rectify the problem, check first that the wheel speed sensor is in fact mounted to the transmission housing, then
proceed as follows:
Connect the All Round Tester to the control unit;
—Access menu 1 (LIFT P.) and select option 2 (settings);
With the settings menu displayed, enter the correct value of the "WHEELS" parameter, following the directions
given in the "Procedure for setting up the electronic lift".
59
5
vehicle
electronic power-lift
241
www.maskinisten.net
www.classicmachinery.net

Table of Contents

Related product manuals