SAMES KREMLIN 20F50 - Page 123

582156110-EN-indC-Pump-20F50 pH.docx 20/11/2020
123
 Place the suction flange/exhaust flange assembly on
the 4 tie rods (3).
 Place the washers (5).
 Screw on the 4 nuts (4) using a 17 mm socket wrench.
 Place the ball (32) on the exhaust valve seat (34).
 Apply adhesive (Loctite 5772) to the piston thread
(24).
 Place the exhaust valve (34) and screw it manually at
the contact.
Tools needed
4
5
3
32
34
34
Loctite 5772
17