SAMES KREMLIN 20F50 - Fluid Section; Spray Gun; Filter

20/11/2020 582156110-EN-indC-Pump-20F50 pH.docx
52
Fluid section
Daily
 Detect leaks at connections.
 Check the condition of the hoses.
 Clean the piston of the pump. Do not let the fluid dry
on it.
 Manoeuver all the valves of the installation.
 Clean the site and the environment.
Once a month
Check that the air regulator and pressure gauge are working
properly.
Every year
 Disassemble the fluid section fully.
 Clean all parts. Install new seals when reassembling
the pump (see replacement seal kit).
 Put grease on the piston and inside the cylinder, to
avoid damaging the seals.
 Fit new parts if necessary.
Spray gun
Comply with the usual instructions of spray gun servicing (refer to
spray gun instruction manual).
Filter
The pump is mounted with a filter at the fluid outlet. Comply with the
usual instructions of filter servicing.
 You must clean regularly the filter element to prevent
from the material clogging.