Samson 3347 - Page 71

EB 8097 EN 14-7
DECLARATION OF INCORPORATION DC043
2022-12
SAMSON REGULATION SAS • 1 rue Jean Corona • 69120 Vaulx-en-Velin
T
el.: +33 (0)4 72 04 75 00 • E-mail: france@samsongroup.com • Internet: www.samson.fr
BNP Paribas
N° compte 0002200215245 • Banque 3000401857
I
BAN FR7630004018570002200215245 • BIC (code SWIFT) BNPAFRPPVBE
Société par actions simplifiée au capital de 10 000 000 € • Siège social : Vaulx-en-Velin
N°
SIRET: RCS Lyon B 788 165 603 00127 • N° de TVA: FR 86 788 165 603 • Code APE 2814Z
Crédit Lyonnais
N° compte 0000060035B41 • Banque 3000201936
I
BAN FR9830002019360000060035B41 • BIC (code SWIFT) CRLYFRPP
Page 1
WEEE N° FR025665
Declaration of Incorporation in compliance with Machinery Directive 2006/42/EC
For the following products:
Type 3347 Pneumatic Control & Hygienic Angle Valve
We certify that the Type 3347 Pneumatic Control & Hygienic Angle Valves are partly completed machinery as
defined in the Machinery Directive 2006/42/EC and that the safety requirements stipulated in Annex I, 1.1.2,
1.1.3, 1.1.5, 1.3.2, 1.3.4 and 1.3.7 are observed. The relevant technical documentation described in Annex
VII, part B has been compiled.
Products we supply must not be put into service unt
il the final machinery into which it is to be incorporated has
been declared in conformity with the provisions of the Machinery Directive 2006/4
2/EC.
Operators are obliged to install the products observing the accepted industry codes and practices (good
engineering practice) as well as the mounting and operating instructions. Operators must take appropriate
precautions to prevent hazards that could be caused by the process medium and operating pressure in the
valve as well as by the signal pressure and moving parts.
The permissible limits of application and
mounting instructions for the products are specified in the associated
data sheets as well as the mounting and operating instructions; the documents are available in electronic form
on the Internet at www.samsongroup.com.
For product descriptions of the valve, refer to Mounting and Operating Instructions EB 8097.
Referenced technical standards and/or specifications:
 VCI, VDMA, VGB: "Leitfaden Maschinenrichtlinie (2006/42/EG) — Bedeutung für Armaturen, Mai 2018"
[German only]
 VCI, VDMA, VGB: "Zusatzdokument zum „Leitfaden Maschinenrichtlinie (2006/42/EG) — Bedeut
ung für
Armaturen vom Mai 2018" [German only], based on DIN EN ISO 12100:201 1-03
Comments:
 See mounting and operating instructions for residual hazards.
 Also observe the referenced documents listed in the mounting and operation instructions.
Persons authorized to compile the technical file:
SAMSON REGULATION SAS – 1 rue Jean Corona – FR-69120 VAULX-EN-VELIN
Vaulx-en-Velin, 23
rd
December 2022
B
runo Soulas
G
eneral Director
H
ead of Strategy and Development
J
oséphine Signoles-Fontaine
H
ead of QSE department