EB 8313-3 EN 1-3
Safety instructions and measures
Responsibilities of operating personnel
Operating personnel must read and understand these mounting and operating instructions as
well as the referenced documents and observe the specied hazard statements, warnings
and caution notes. Furthermore, the operating personnel must be familiar with the applicable
health, safety and accident prevention regulations and comply with them.
Servicing explosion-protected devices
If a part of the device on which the explosion protection is based needs to be serviced, the
device must not be put back into operation until a qualied inspector has assessed it accord-
ing to explosion protection requirements, has issued an inspection certicate or given the de-
vice a mark of conformity. Inspection by a qualied inspector is not required if the manufac-
turer performs a routine test on the device before putting it back into operation. Document
the passing of the routine test by attaching a mark of conformity to the device. Replace ex-
plosion-protected components only with original, routine-tested components by the manufac-
turer.
Devices that have already been operated outside hazardous areas and are intended for fu-
ture use inside hazardous areas must comply with the safety requirements placed on serviced
devices. Before being operated inside hazardous areas, test the devices according to the
specications for servicing explosion-protected devices.
Maintenance, calibration and work on equipment
Î Only use intrinsically safe current/voltage calibrators and measuring instruments for in-
terconnection with intrinsically safe circuits to check or calibrate the equipment inside or
outside hazardous areas.
Î Observe the maximum permissible values specied in the certicates for intrinsically safe
circuits.
Referenced standards and regulations
The Type3372 Electropneumatic Actuator fullls the requirements of the Directives
2014/30/EU and 2014/34/EU. The 'Certicates' section contains this declaration of con-
formity.
To Next Page
Loading...
