Samson 3375-10 - 4 Shipment and On-Site Transport; Accepting the Delivered Goods; Removing the Packaging from the Actuator; Transporting the Actuator

EB 8332-1 EN 4-1
Shipment and on-site transport
4 Shipment and on-site trans-
port
The work described in this section is only to
be performed by personnel appropriately
qualiedtocarryoutsuchtasks.
4.1 Accepting the delivered
goods
After receiving the shipment, proceed as fol-
lows:
1. Check the scope of delivery. Compare
the shipment received with the delivery
note.
2. Check the shipment for transportation
damage. Report any damage to
SAMSON and the forwarding agent
(refer to delivery note).
4.2 Removing the packaging
from the actuator
Do not remove the packaging until immedi-
ately before mounting and start-up.
1. Remove the packaging from the electric
actuator.
2. Dispose of the packaging in accordance
with the valid regulations.
4.3 Transporting the actuator
− Protect the actuator against external in-
uences(e.g.impact).
− Protect the actuator against moisture and
dirt.
− Observe the permissible transportation
temperatureof–20to+70°C.
4.4 Lifting the actuator
− Use suitable equipment to lift the actua-
tor.
4.5 Storing the actuator
Risk of electric actuator damage due to
improper storage.
Î Observe the storage instructions.
Î Avoid long storage times.
Î Contact SAMSON in case of different
storage conditions or longer storage
times.
We recommend regularly checking the elec-
tric actuator and the prevailing storage con-
ditions during long storage periods.
Note
NOTICE
!
Note