EB 8332-1 EN 5-11
Installation
5.6 Electrical connection
Risk of fatal injury due to electric shock.
Î Upon installation of the electric cables,
you are required to observe the regula-
tions concerning low-voltage installations
according to DINVDE0100 as well as
the regulations of your local power sup-
plier.
Î Use a suitable voltage supply which
guarantees that no dangerous voltages
reach the device in normal operation or
in the event of a fault in the system or
any other system parts.
Î Only perform the electrical connection
after switching off the supply voltage.
Make sure the supply voltage cannot be
switched on again unintentionally.
A maximum of three cable glands can be at-
tached to the housing for cable entry.
Connecting the supply voltage
Î Connect the wiring as shown in
Fig.5-11.
Î Guidethecablestothespring-cage
terminals from the top.
After applying the supply voltage, the actua-
tor is ready for use.
A maximum of three cable glands can be
mounted to the housing for cable entry.
DANGER
!
Note
To Next Page
Loading...
