Samson 3730-2 - Page 107

EB 8384-2 EN 107
Operating the positioner
By entering the blocking position (Code 35), closing direction (Code 34), pin position (Code
4), nominal range (Code 5) and direction of action (Code 7), the positioner can calculate the
positionerconguration.
Perform a reset before re-initializing the positioner if the substitute positioner has already
been initialized. Refer to section7.9.
Enable conguration:
Ifnosettingsareenteredwithin120seconds,theenabledcongurationfunctionbecomesin-
valid.
1. Turn untilCode3appears(reading:
No).
2. Press , the code number 3 blinks.
3. Turn
until YES appears.
4. Press
toconrm(reading: ).
Enableconguration
Default: No
Enter the pin position and nominal range:
1. Turn untilCode4appears.
2. Press
, the code number 4 blinks.
3. Turn
to select pin position on lever (see
relevant section on attachment).
4. Press toconrm.
5. Turn
untilCode5appears.
6. Press
, the code number 5 blinks.
7. Turn
and set nominal travel of the valve.
8. Press
toconrm.
mm
Pin position
Default: No
mm
Nominal range
(lockedwhenCode4=
No)
NOTICE
!