Samson 3730-2 - Measures for Preparation; Unpacking; Storage

EB 8384-2 EN 41
Measures for preparation
4 Measures for preparation
After receiving the shipment, proceed as fol-
lows:
1. Check the scope of delivery. Compare
the shipment received with the delivery
note.
2. Check the shipment for transportation
damage.Reportanytransportationdam-
age.
4.1 Unpacking
Risk of positioner damage due to foreign
particles entering it.
Do not remove the packaging and protective
lm/protective caps until immediately before
mounting and start-up.
1. Removethepackagingfromtheposition-
er.
2. Dispose of the packaging in accordance
with the valid regulations.
4.2 Transporting
− Protect the positioner against external in-
uences(e.g.impact).
− Protect the positioner against moisture
and dirt.
− Observe transport temperature depend-
ing on the permissible ambient tempera-
ture(seetechnicaldatainsection3.6).
4.3 Storage
Risk of positioner damage due to improper
storage.
− Observe the storage instructions.
− Contact SAMSON in case of different stor-
age conditions or long storage periods.
Storage instructions
− Protect the positioner against external in-
uences(e.g.impact,shocks,vibration).
− Do not damage the corrosion protection
(coating).
− Protect the positioner against moisture
and dirt. In damp spaces, prevent con-
densation. If necessary, use a drying
agent or heating.
− Observe storage temperature depending
on the permissible ambient temperature
(seetechnicaldatainsection3.6).
− Store positioner with closed cover.
− Seal the pneumatic and electrical con-
nections.
NOTICE
!
NOTICE
!