Samson 3730-2 - Page 142

142 EB 8384-2 EN
Appendix
Diagnosis errors
Error codes – Recommended
action
Condensed state message active, when prompted, Err appears.
Whenfaultalarmsexist,theyaredisplayedhere.
79 Diagnostic messages Messages generated by the extended diagnostics
Statusclassication Maintenancerequired(cannotbeclassied)
80 Diagnostic parame-
ters
Error in parameters not critical to control operation.
Statusclassication Maintenancerequired(cannotbeclassied)
Recommendedaction Conrmerror.Checkand,ifnecessary,performanewreferencetest.
81 Reference graphs Error occurred during plotting the reference graphs for drive signal y
steady-state or drive signal y hysteresis.
• Referencetestcanceled
• Referencelinefordrivesignalysteady-stateordrivesignalyhyster-
esis was not adopted.
Error messages are not yet saved in a non-volatile memory. They cannot
be reset.
Statusclassication [No message]
Recommendedaction Check and, if necessary, perform a new reference test.