Samson 4763 - Shipment, Handling, and Storage; Goods Acceptance and Packaging; Storage Instructions

EB 8359-2 EN 4-1
Shipment and on-site transport
4 Shipment and on-site trans-
port
The work described in this section is only to
be performed by personnel appropriately
qualied to carry out such tasks.
4.1 Accepting the delivered
goods
After receiving the shipment, proceed as fol-
lows:
1. Check the scope of delivery. Check that
the specications on the nameplate of the
positioner match the specications in the
delivery note. See the 'Markings on the
device' section for nameplate details.
2. Check the shipment for transportation
damage. Report any damage to SAM-
SON and the forwarding agent (refer to
delivery note).
4.2 Removing the packaging
from the positioner
Observe the following sequence:
Î Do not remove the packaging and the
protective caps on the pneumatic ports
until immediately before installation.
Î Dispose and recycle the packaging in ac-
cordance with the local regulations.
4.3 Transporting the positioner
Î Pack the positioner properly to comply
with terms of transportation.
Transport instructions
− Protect the positioner against external in-
uences (e.g. impact).
− Protect the positioner against moisture
and dirt.
− Observe transport temperature depend-
ing on the permissible ambient tempera-
ture (see the 'Design and principle of op-
eration' section).
4.4 Storing the positioner
Risk of device damage due to improper
storage.
Î Observe the storage instructions.
Î Avoid long storage times.
Î Contact SAMSON in case of different
storage conditions.
We recommend regularly checking the posi-
tioner and the prevailing storage conditions
during long storage periods.
Storage instructions
− Protect the positioner against external in-
uences (e.g. impact, shocks, vibration).
NOTICE
!
Note