EB 8359-2 EN 11-1
Removal
11 Removal
The work described in this section is only to
be performed by personnel appropriately
qualied to carry out such tasks.
Risk of fatal injury due to the ignition of an
explosive atmosphere.
Î The following regulations apply to instal-
lation in hazardous areas: EN60079-14
(VDE0165, Part1).
Î Installation, operation or maintenance of
the positioner must only be performed by
personnel who has undergone special
training or instructions or who is autho-
rized to work on explosion-protected de-
vices in hazardous areas.
Î Put the positioner out of operation (see
the 'Decommissioning' section).
Î Disconnect the wires for electrical input
and remove them from the positioner.
Î Unscrew screw ttings for supply pres-
sure/output at the positioner.
Î To remove the positioner, loosen the fas-
tening screws on the positioner.
DANGER
!
To Next Page
Loading...
