EB 8359-2 EN 7-1
Operation
7 Operation
The positioner is ready for use after it has
been mounted and the pneumatic and elec-
tric connections have been established (see
the 'Installation' section).
Crush hazard arising from moving parts on
the valve.
Î Do not touch any moving valve parts
while the control valve is in operation.
Î Before performing any mounting or in-
stallation work on the positioner, put the
control valve out of operation by discon-
necting and locking the supply air and
control signal.
Î Do not impede the movement of the actu-
ator and plug stem by inserting objects
into the yoke.
WARNING
!
To Next Page
Loading...
