Disassembly and Reassembly
Samsung Electronics 47
3-2 Disassembly and Reassembly (cont.)
3-2-6 Removal Instructions for Compressor (cont.)
No. Work Procedure Remark
6
- Unfasten the three screws on the power cables connected to
the compressor and then disconnect the power cables.
※ When reassembling it after inspection, be sure to tightly fas-
ten the screws.∙ Check the cable connection for the U, V and W
phases.
∙
A loosely fastened screw may cause a fire. Exercise caution.
※ Terminal fastened with a torque 0f 25 ~ 35 kgf·m.
- Separate the velcro on the soundproofing felt coveringthe
compressor and remove the felt from the compressor.
- Remove the thermistor on top of the compressor.
Thermistor
- Cut the compressor side port (discharge, VI, suction) using a
ratchet cutter.Check the cutting point shown in the images.
* Do not use saws or grinders. Copper chips may go into the set
and cause failure.
To Next Page
Loading...
