Samsung Electronics
Service Manual
Disassembly and Reassembly
5-10
1. Open the ADF Ass'y
2. First remove the ADF Harness from the Platen Ass'y
and then pull the ADF Ass'y upward in the direction of
arrow, as shown below.
3. To remove the ADF Engine part, first remove the eight
screws securing the ADF Engine part to the Cover
Platen and then release the ADF Engine part in the
direction of arrow.
At that time the TX Stacker automatically release it
self at right side, as shown below.
4. Remove the two screws securing the ADF Harness to
the Cover Connector and then take care to thread the
ADF Harness through the Cover Platen.
5.10 ADF Ass'y
To Next Page
Loading...
