Samsung Electronics
Service Manual
Disassembly and Reassembly
5-26
1. Before you remove the Regi Roller, you should
remove:
- HVPS (Refer to 5.14)
- LIU Unit (Refer to 5.15)
- Shield Main Lower(with Main PBA) (Refer to 5.16)
- Main Drive Ass'y (Refer to 5.17)
2. First remove the Plan Washer securing the Regi
Clutch and then pull the Regi Clutch, as shown below.
3. Remove the E-ring below the both side of the Regi
Roller, as shown below.
4. Take off the Sheet and then remove the Regi Pulley,
as shown below.
5. To remove the Regi Roller, first slide the left side to
right side and then take out the left side, as shown
below.
Notice : Do not grab the rubber part of the Regi Roller, it
may cause a malfunction due to a foreigen
object.
To Next Page
Loading...
