Samsung CLX-3160FN - Exit Roller Unit

Samsung Electronics
Service Manual
Disassembly and Reassembly
5-32
5.22 Exit Roller Unit
1. Before you remove the Exit Roller Unit, you should
remove:
- Middle Cover Ass'y (Refer to 5.12)
2. Remove the four screws and two nuts securing the
Fuser Terminal Unit and remove it, as shown below.
3. For easy disassembly, remove the one screw secur-
ing the Exit Sensor and remove it.
4. Remove the three screws securing the Exit Roller
Unit.
5. First unlatch the lock device below the both side of the
Exit Frame using a flat-blade screwdriver and then
pull the Exit Roller Unit, as shown below.
Exit Roller Unit
Lock Device
Fuser Terminal Unit
Exit Sensor