Disassembly and Reassembly
Samsung Electronics
Service Manual
5-25
5.18 SMPS
1. Before you remove the SMPS, you should remove:
- Side Cover Right (Refer to 5.9)
2. Unplug the all connectors(Main PBA, Inlet, Fuser_AC)
from the SMPS, as shown below.
3. Remove the four screws securing the SMPS and
remove it.
4. If necessary, first remove the Shield Main Lower
(refer to 5.16) and Main Drive Ass'y (refer to 5.17) and
then remove the one screw securing the Shield SMPS
and remove it in the direction of arrow.
To Next Page
Loading...
