Samsung Electronics
Service Manual
Disassembly and Reassembly
5-34
5.23 LSU
1. Before you remove the LSU, you should remove:
- OPC DEV Unit (Refer to 5.4)
- ITB Unit (Refer to 5.5)
- Middle Cover Ass'y (Refer to 5.12)
2. Apply light pressure to the right side of the LSU Cover
Unit and remove it in the direction of arrow.
3. Unplug the two connectors and then remove the four
screws securing the LSU and remove it in the
direction of arrow.
5.24 MP Unit
1. Before you remove the MP Unit, you should remove:
- Cassette Unit (Refer to 5.3.1)
2. Down the MP Unit, as shown below.
3. Apply light pressure to the both side of the MP Unit
and pull it in the direction of arrow, as shown below.